SS-WALL-TH iButton Reader The female end of the

The female end of the RJ-45 connector should look like the following:

The DS9092+ Probe with Molex Connector is also compatible with most CalAmp products that feature a female Molex Connector

margin: 16px 0 12px

One end of the cable can be used as either a dwelled or momentary contact for an iButton® in order to read information off of the iButton®

The Link is designed to operate reliably on long and short 1-Wire® busses

SS-WALL-TH iButton Reader The female end of theThis multi use 1 Wire based sensor can be embedded into walls or fixtures to monitor temperature and humidity. The case has a threaded wall holder that can be screwed into drywall with a few twists, allowing the sensor body to slide in and be almost flush with the wall. A small opening in the front allows the sensor to measure the temperature and humidity; this opening should never be covered or filled. The sensor comes with pre stripped 18 gauge